Program System speed dial on Legend

System Speed Dial lets the system manager program frequently used numbers that can be dialed from any extension (including data workstations) using a 3-digit code. The user lifts the handset or press Speaker then Presses a programmed Speed Dial button, or presses Feature and dials the 3-digit Speed Dial code.

System Speed Dial is available on all releases.

Telephones: All except Queued Call Console (QCC) operators.

Factory setting: 600 – 729 (cannot be changed).

Programming Code:
Onto a button – *24 + System Speed Dial code

To administer System Speed Dial numbers from the System Programming console or through System Programming and Maintenance (SPM):

  1. Press Menu.
  2. Press System Program.
  3. Press Exit or Start.
  4. Press More or Right Arrow Key.
  5. Press Labels.
  6. Press Directory.
  7. Press System.
  8. Dial the code number (600-729).
  9. Press Enter.
  10. Press letters for labeling (A-F are on the display, G-Z are on the 20 line buttons, in order from left to right, top to bottom).
  11. Press Enter.
  12. Dial telephone number (include any dial-out code needed, e.g. 9 for ARS).
  13. Press Enter.
  14. Press Yes OR No for display number while dialing (selecting No makes the number marked allowing restricted extension to use the speed dial).
  15. Press Enter.
  16. Press Exit or Back.
  17. Press Home or Exit to exit programming mode.

Use the procedure below to program a System Speed dial onto a button:

On an Analog multiline phone:

  1. Slide the T/P (Test/Program) switch on the left-hand side of the telephone down to the P (Programming) position to enter programming mode.
  2. Press the button you want to program for the specific System Speed dial and dial *24 + System Speed Dial code.
  3. Slide the T/P switch back to the center to exit programming mode.

On an ETR, MLS or MLX phone:

  1. Press Feature or # and dial 00 to enter programming mode.
  2. Press the button you want to program for the specific System Speed dial and dial *24 + System Speed Dial code.
  3. Press Feature or # and dial *00 to exit programming mode.

On an MLX display phone:

  1. Press Menu to enter programming mode.
  2. Press Ext Program.
  3. Press Start and then press the button you want to program. If a feature is already administered on the button, press Delete to
  4. remove that feature.
  5. Press the button again.
  6. Press List Feature and select the feature to be programmed [SpdDl]. If the desired feature is not a choice, press More or Right Arrow Key until the feature is displayed.
  7. Once you have located the feature, press the button next to it and then press Enter.
  8. Press Exit or Back.
  9. Press Home or Exit to exit programming mode.
Print Friendly, PDF & Email